Selector Lever Assembly: Installation
- Torque:
80 lb.in (9 Nm)
- On both sides.
Torque: 71 lb.in (8 Nm)
- Torque:
80 lb.in (9 Nm)
- On both sides.
Torque: 71 lb.in (8 Nm)
- On both sides.
- Torque:
62 lb.in (7 Nm)
- Torque:
35 lb.in (4 Nm)
- On both sides.
- Release the parking brake.
-
NOTE: Anytime the parking brake switch electrical connector has been disconnected, the EPB system is deactivated and a DTC is stored in the ABS module. Perform the following step to restore the EPB system and clear the ABS module DTC .
Apply and release the parking brake twice within 5 seconds, pausing with the switch in the NEUTRAL position for approximately one-half second between each apply and release.
- Adjust the selector lever cable when a new selector lever is installed.
Refer to: SELECTOR LEVER CABLE ADJUSTMENT .