Powertrain Control Module (PCM) - 2.0L GTDI, 3.5L GTDI: Installation

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

1.
- Tighten to 8 Nm (71 lb-in).

Courtesy of FORD MOTOR COMPANY

Courtesy of FORD MOTOR COMPANY

3.

Install the cowl panel grille. Refer to Front End Body Panels .

4.

NOTE: If the PMI procedure was not successful in downloading the data from the vehicle's original PCM, then the oil life data of the vehicle is lost. If this occurs, and the oil life cannot be determined through service history or customer interview, it is recommended the vehicle engine oil and filter be changed and the oil change minder reset.

Restore the module configuration. Carry out the module configuration restore steps of the PMI procedure. Refer to Module Configuration .

5.

Reprogram the PATS. Carry out the Parameter Reset procedure. Refer to Anti-Theft Passive Anti-Theft System (PATS) .

6.

Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.