Pinpoint Test P: DTC (Diagnostic Trouble Code) U3003:17

P1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) P0563 (POWERTRAIN CONTROL MODULE (PCM)), U3003:17 OR U3006:17 SET IN OTHER MODULES
- Ignition ON.
- Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC U3003:17, U3006:17 or P0563 ( PCM ) set in more than one module?
1. Yes : REFER to: CHARGING SYSTEM - 2.0L DURATEC-HE (125KW/170PS) - MI4 .
  REFER to: CHARGING SYSTEM - 2.0L ECOBOOST (184KW/250PS) - MI4 .
2. No : GO to P2
P2 CHECK THE BATTERY VOLTAGE
- Turn off all interior/exterior lights and accessories.
- Start and run the engine at approximately 2, 000 RPM for 3 minutes while monitoring the battery voltage.
Does the battery voltage rise to 15.9 volts or higher?
1. Yes : REFER to: CHARGING SYSTEM - 2.0L DURATEC-HE (125KW/170PS) - MI4 .
  REFER to: CHARGING SYSTEM - 2.0L ECOBOOST (184KW/250PS) - MI4 .
2. No : GO to P3
P3 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U3003:17
- Turn the engine off.
- Ignition ON.
- Using a diagnostic scan tool, perform the self-test.
- Clear the Continuous Memory Diagnostic Trouble Codes (CMDTCs).
- Carry out the BCM self-test.
Is DTC U3003:17 still present?
1. Yes : INSTALL a new BCM .
  REFER to: BODY CONTROL MODULE (BCM) .
2. No : The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.