LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Fiesta ST >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> General Procedures >> Supplemental Restraint System (SRS) Depowering and Repowering >> Repower

Supplemental Restraint System (SRS) Depowering and Repowering: Repower

NOTE: The SRS  must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Install the BCM  fuse 20 (10A).
  2. Connect the battery.

    Refer to: BATTERY DISCONNECT AND CONNECT .

  3. Sit in the driver seat in an upright position. Make sure no objects are between you and the driver airbag, driver lower airbag, side airbag or side air curtain.

    Dimension  : 10.0 in (25.4 cm)

  4. Move the driver seat to the rearmost position.
  5. Turn the ignition from OFF to ON.
    • Prove out the SRS  as follows: Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the airbag warning indicator with the airbag modules installed. The airbag warning indicator illuminates continuously for approximately 6 seconds and then turns off. If a SRS  fault is present, the airbag warning indicator either fails to light, remains lit continuously or flashes.
    • The flashing may not occur until approximately 30 seconds after the ignition has been turned from OFF to ON. This is the time required for the RCM  to complete the testing of the SRS  . If the airbag warning indicator is inoperative and a SRS  fault exists, "Airbag Malfunction Service Now" displays in the message center. If this occurs, diagnose and repair the airbag warning indicator and any SRS  faults.
  7. Using a scan tool, clear all Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
scientia non olet · About LEMON Manuals