General Procedure

Disconnect the selector lever cable end from the manual control lever.

Fig 1: Locating Selector Lever Cable End
Courtesy of \
Place the selector lever in DRIVE.

Fig 2: Locating Selector Lever DRIVE Position
Courtesy of \
Place the manual control lever in DRIVE.
1. Rotate the manual control lever clockwise until it stops.
2. Rotate the manual control lever counterclockwise one detent.
  
  Fig 3: Rotating Manual Control Lever
  Courtesy of \
Unlock the adjuster.
1. Pry the latch up.
2. Push the lock tab to slide it over.
  
  Fig 4: Sliding Lock Tab
  Courtesy of \
Slide the selector lever cable end forward or backward to align it with the manual control lever.

Fig 5: Sliding Selector Lever Cable End
Courtesy of \
With the adjuster locking tab released, connect the selector lever cable end to the manual control lever.

Fig 6: Locating Selector Lever Cable End
Courtesy of \
NOTE: After locking the adjuster, pull back on the adjuster to make sure it is securely installed.

Slide the release tab back to lock the adjuster.

Fig 7: Sliding Release Tab
Courtesy of \
Verify the vehicle starts in PARK and NEUTRAL only and the reverse lamps illuminate in REVERSE.