LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Transit Connect XL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> MULTIFUNCTION Electronic Modules >> Diagnosis And Testing >> Generic Electronic Module (GEM) >> Pinpoint Tests >> Pinpoint Test A: DTC B1317 >> Pinpoint Test A: DTC B1317

Pinpoint Test A: DTC B1317

NOTE: DTC B1317 may be stored in the module memory due to previous battery charging or vehicle jump starting events.
  1. A1 CHECK FOR DTC B1317 OR P0563:00 SET IN OTHER MODULES 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: (All Modules) Self-Test.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC B1317 or DTC P0563:00 (PCM) set in more than one module? 
    • Yes  : REFER to CHARGING SYSTEM to diagnose an overcharging condition.
    • No  : GO to A2.
  2. A2 CHECK THE BATTERY VOLTAGE 
    • Turn off all interior/exterior lights and accessories.
    • Start and run the engine at approximately 2, 000 RPM for 3 minutes while monitoring the battery voltage.
    • Does the battery voltage rise to 16.5 volts or higher? 
    • Yes  : REFER to CHARGING SYSTEM to diagnose an overcharging condition.
    • No  : GO to A3.
  3. A3 RECHECK FOR DTC B1317 
    • Turn the engine off.
    • Ignition ON.
    • Carry out the GEM self-test.
    • Is DTC B1317 present? 
    • Yes  : INSTALL a new GEM. REFER to GENERIC ELECTRONIC MODULE (GEM)  . TEST the system for normal operation.
    • No  : The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals