DTC P160A: Control Module Vehicle Options Reconfiguration Error
WARNING: This page is about a different variant/trim than selected.
DTC P160A: CONTROL MODULE VEHICLE OPTIONS RECONFIGURATION ERROR
| Description: | This DTC sets when the body control module (BCM) detects a mismatch in configuration data and programmable parameters between the PCM and BCM. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Reprogram or update the calibration. If the PCM already has the latest calibration, carry out the RELEARN VEHICLE DATA procedure from the SERVICE FUNCTIONS menu on the scan tool. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a replacement PCM. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the appropriate Description article, Possible Causes and Diagnostic Aids for the DTC. | ||