LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System And Stability Control >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. NOTE: If the wheel speed sensor is disconnected with the ignition in the ACC or RUN position, a DTC will be set in the ABS module.

    Turn the ignition to the OFF position.

  3. Disconnect the wheel speed sensor electrical connector.
  4. Disconnect the 3 wheel speed sensor harness pin-type retainers.
  5. Disconnect the 2 wheel speed sensor grommets from the brake hose clips.
  6. Remove the wheel speed sensor bolt.
    • To install, tighten to 15 Nm (133 lb-in).
  7. Remove the wheel speed sensor and harness assembly.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals