SCCM DTC Table
SCCM DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure |
|
| B1051:09 | Front Washer Switch: Component Failure |
|
| B10AD:02 | Rain Sensor: General Signal Failure | GO to PINPOINT TEST F |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | GO to PINPOINT TEST F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. REFER to: Rain Sensor . |
| B10AD:55 | Rain Sensor: Not Configured | PERFORM the Programmable Module Installation (PMI) for the SCCM using as built data. |
| B1131:02 | Wiper motor module: General Signal Failure | GO to PINPOINT TEST B |
| B1131:08 | Wiper motor module: Bus Signal/Message Failure | GO to PINPOINT TEST B |
| B1131:49 | Wiper motor module: Internal Electronic Failure |
|
| B1131:55 | Wiper motor module: Not Configured | PERFORM the Programmable Module Installation (PMI) for the SCCM using as built data. |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | DIAGNOSE the symptom present with the wiper/washer system. REFER to the SYMPTOM CHART . |
| B12F7:09 | Single Wipe Switch: Component Failure |
|
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: STEERING WHEEL AND COLUMN ELECTRICAL COMPONENTS . |