LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Automatic DCT Trans >> Repair and Diagnosis >> Body & Frame >> Seat System - Seats >> Disassembly And Assembly >> Seat Backrest - Front >> Assembly

Seat Backrest - Front: Assembly

  1. Install the static lumbar support.
  2. Install the 2 backrest foam retainer clips to the backrest frame.
  3. Install the anti-squeak bag to the backrest frame.
  4. Install the backrest foam pad.
    5. NOTE: Passenger seat shown in illustration, driver seat similar.
    Fig 1: Routing Side Air Bag Module Wire Harness Through Backrest Foam Pad Opening
    G06940282Courtesy of FORD MOTOR CO.
  5. Route the side air bag module wire harness through the backrest foam pad opening.
  6. Position the side air bag module studs through the backrest frame holes and install the nuts in the sequence shown in illustration.
    • Tighten to 9 Nm (80 lb-in).
    Fig 2: Identifying Side Air Bag Module Stud Nuts Tightening Sequence
    G06940283Courtesy of FORD MOTOR CO.
  7. Attach the side air bag module wire harness retainer to the rear of the backrest frame.
  8. Install the seat backrest cover. For additional information, REFER to Seat Backrest Cover - Front .
  9. Install the front seat backrest. For additional information, REFER to Seat Backrest - Front .
scientia non olet · About LEMON Manuals