| P0512 |
Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position |
CARRY OUT the Ignition Switch Component Test. Refer to OEM WIRING DIAGRAMS COMPONENT TESTING
for component testing.
If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to voltage. |
| P0705 |
Transmission Range Sensor A Circuit (PRNDL Input): No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the Transmission Range (TR) sensor concern. |
| P0706 |
Transmission Range Sensor "A" Circuit Range/Performance: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P0707 |
Transmission Range Sensor "A" Circuit Low: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P0708 |
Transmission Range Sensor "A" Circuit High: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P0709 |
Transmission Range Sensor "A" Circuit Intermittent: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P161A |
Incorrect Response From Immobilizer Control Module |
REFER to
ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS)
. |
| P1702 |
Transmission Range Sensor Circuit Intermittent: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P1705 |
Transmission Range Circuit Not Indicating Park/Neutral During Self Test: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P1921 |
Transmission Range Signal: No Sub Type Information |
REFER to
AUTOMATIC TRANSMISSION (6R80)
to diagnose the TR sensor concern. |
| P2532 |
Ignition Switch Run Position Circuit High |
GO to PINPOINT TEST G . |
| P2535 |
Ignition Switch Run/Start Position Circuit High |
GO to PINPOINT TEST G . |
| All other PCM DTCs |
- |
REFER to
ELECTRONIC ENGINE CONTROLS
. |