LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Explorer Base, 2.0L Eng VIN 9 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System - General Information >> General Procedures >> Cylinder Block Distortion >> General Procedure

General Procedure

NOTE: Refer to General Specifications in the appropriate engine service information for the specification.
  1. NOTE: Use a straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.01 mm (0.0004 in) from end-to-end.

    Use a straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.

    G06064116
scientia non olet · About LEMON Manuals