LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge Sport, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6F50/6F55 >> Specifications

Automatic Transmission - 6F50/6F55: Specifications

MATERIAL SPECIFICATIONS

Item Specification Fill Capacity
Motorcraft® MERCON® LV Automatic Transmission Fluid
XT-10-QLVC (US); CXT-10-LV12 (Canada)		 MERCON® LV 10.5L (11.1 qt)
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
ACL assembly bracket bolt 11 - 97
ACL outlet pipe clamp 5 - 44
Battery tray bolts 10 - 89
Catalytic converter nuts (1) 40 30 -
Catalytic converter support bracket bolts 20 - 177
Cover assembly-to-transmission case bolts(1) - - -
Differential carrier baffle bolts 12 - 106
Driveshaft bolts 70 52 -
Fluid reservoir bolts 12 - 106
Fluid pump-to-torque converter housing bolts 12 - 106
Intermediate shaft steering gear bolt 23 17 -
Line pressure tap plug 9 - 80
Lower bumper-to-subframe support nuts 10 - 89
Main control cover bolts(1) - - -
Main control valve body bolts(1) - - -
Manual control lever nut(1) - - -
OSS sensor bolt 12 - 106
Park pawl retainer bolts 12 - 106
Power steering banjo bolt 48 35 -
Power steering rack bolts 107 79 -
Power steering rack heat shield bolts 6 - 53
Power steering tube bolts 9 - 80
PTU support bracket bolts 70 52 -
PTU-to-transmission bolts 90 66 -
Roll restrictor bracket-to-transmission bolts 90 66 -
Roll restrictor heat shield nuts 9 - 80
Roll restrictor-to-subframe through bolt 115 85 -
Roll restrictor-to-transmission through bolt 115 85 -
Selector lever cable bracket bolts 12 - 106
Shim gauge bolts 24 18 -
Solenoid body bolts(1) - - -
Stabilizer bar bracket bolts 48 35 -
Starter battery terminal 12 - 106
Starter bolts 26 19 -
Starter solenoid terminal 6 - 53
Stator support feed tube bolts (hex head) 12 - 106
Stator support feed tube bolts (Torx head) 7 - 62
Stator support-to-torque converter housing bolts(1) - - -
Subframe nuts 150 111 -
Subframe support bracket bolts 90 66 -
Tie-rod ends nuts 48 35 -
Torque converter bolts(1) - - -
Torque converter housing bolts 48 35 -
Transaxle support insulator bolts 55 41 -
Transaxle support insulator bracket bolt 80 59 -
Transaxle support insulator bracket nuts 63 46 -
Transaxle support insulator through bolt 175 129 -
Transmission fluid cooler thermal bypass valve bracket nuts 9 - 80
Transmission fluid cooler tube bolt 9 - 80
Transmission fluid cooler tube fittings 30 22 -
Transmission fluid drain plug 9 - 80
TSS sensor bolt 12 - 106
Torque converter housing-to-transmission case bolts(1) - - -
Valve body assembly bolts 12 - 106
(1) Refer to the procedure in this article.
GENERAL SPECIFICATIONS

Item Specification
6F50 Transaxle Weight 100 kg (220 lb)
SOLENOID OPERATION CHART

Base Selector Lever Position PCM Commanded Gear SSA NL (1, 2, 3, 4) SSB NH (3, 5, R) SSC NL (2, 6) SSD NH (L, R 4, 5, 6) SSE (On/Off) NC TCC NL
P P Off On Off Off On Off
R R Off Off Off Off On Off
N N Off On Off Off On Off
D 1 On On Off Off (1) On (2) Off
  2 On On On On Off Off
  3 On Off Off On Off Off
  4 On On Off Off Off On/Off
  5 Off Off Off Off Off On/Off
  6 Off On On Off Off On/Off
(1) Turns on above 8 km/h (5 mph).
(2) Turns off above 8 km/h (5 mph).

NC = Normally closed
NH = Normally high
NL = Normally low
PRESSURE CHART

Gear Line Pressure at Idle KPa (psi) Line Pressure at WOT Stall KPa (psi)
Minimum Maximum Minimum Maximum
P 344.7 kPa (50 psi) 448.2 kPa (65 psi) - -
R 551.6 kPa (80 psi) 689.5 kPa (100 psi) 1, 689.2 kPa (245 psi) 2, 068.4 kPa (300 psi)
N 344.7 kPa (50 psi) 448.2 kPa (65 psi) - -
D 482.6 kPa (70 psi) 620.5 kPa (90 psi) 1, 689.2 kPa (245 psi) 2, 068.4 kPa (300 psi)
CLUTCH APPLICATION CHART

Gear Forward (1, 2, 3, 4) Direct (3, 5, R) Intermediate (2, 6) Low/Reverse (1, R) Overdrive (4, 5, 6) Low - OWC
Park       H    
Reverse   D   H    
Neutral       H    
1st Gear D H     H   H
2nd Gear D H   H      
3rd Gear D H D        
4th Gear D H       D  
5th Gear D   D     D  
6th Gear D     H   D  
1st Gear Manual H     H    
Planetary Component Front Sun Rear Sun Rear Sun Rear Carrier/Center Ring Rear Carrier/Center Ring Rear Carrier/Center Ring
H = Holding
D = Driven
STALL SPEED CHART

Engine Stall Speed
3.5L/3.7L Ti-VCT 1, 900-2, 500
GEAR RATIO CHART

Gear Ratio
1st/low 4.484:1
2nd 2.872:1
3rd 1.842:1
4th 1.414:1
5th 1:1
6th 0.742:1
Reverse 2.882:1
SHIFT SPEEDS SPECIFICATIONS

Throttle Position Range Shift KM/H MPH
Light D 1-2 14-19 9-12
Throttle D 2-3 24-31 15-19
D 3-4 32-40 20-25
D 4-5 45-56 28-35
D 5-6 63-80 39-50
Medium D 1-2 37-47 23-29
Throttle D 2-3 58-71 36-44
D 3-4 74-93 46-58
D 4-5 108-135 67-84
D 5-6 169-211 105-131
Heavy D 1-2 55-69 34-43
Throttle D 2-3 84-105 52-65
D 3-4 127-158 79-98
D 4-5 167-208 104-129
D 5-6 179-222 111-138
DIFFERENTIAL AND TRANSFER GEAR BEARING PRELOAD SHIM SELECTION CHART

Differential Shim Part Number Transfer Gear Shim Part Number Shim Thickness
7T4Z-4067-A 7T4Z-7H367-A 0.55 mm (0.0217 in)
7T47-4067-B 7T4Z-7H367-B 0.575 mm (0.0226 in)
7T47-4067-C 7T4Z-7H367-C 0.6 mm (0.0236 in)
7T47-4067-D 7T4Z-7H367-D 0.625 mm (0.0246 in)
7T47-4067-E 7T4Z-7H367-E 0.65 mm (0.0256 in)
7T47-4067-F 7T4Z-7H367-F 0.675 mm (0.0266 in)
7T47-4067-G 7T4Z-7H367-G 0.7 mm (0.0276 in)
7T47-4067-H 7T4Z-7H367-H 0.725 mm (0.0285 in)
7T47-4067-J 7T4Z-7H367-J 0.75 mm (0.0295 in)
7T47-4067-K 7T4Z-7H367-K 0.775 mm (0.0305 in)
7T47-4067-L 7T4Z-7H367-L 0.8 mm (0.0315 in)
7T47-4067-M 7T4Z-7H367-M 0.825 mm (0.0325 in)
7T47-4067-N 7T4Z-7H367-N 0.85 mm (0.0335 in)
7T47-4067-P 7T4Z-7H367-P 0.875 mm (0.0344 in)
7T47-4067-Q 7T4Z-7H367-Q 0.9 mm (0.0354 in)
7T47-4067-R 7T4Z-7H367-R 0.925 mm (0.0364 in)
7T47-4067-S 7T4Z-7H367-S 0.95 mm (0.0374 in)
7T47-4067-T 7T4Z-7H367-T 0.975 mm (0.0384 in)
7T47-4067-U 7T4Z-7H367-U 1 mm (0.0394 in)
7T47-4067-V 7T4Z-7H367-V 1.025 mm (0.0404 in)
7T47-4067-W 7T4Z-7H367-W 1.05 mm (0.0413 in)
scientia non olet · About LEMON Manuals