Speed Control Deactivator Switch: Removal
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the speed control deactivator switch electrical connector.
- Rotate the speed control deactivator switch counterclockwise 45 degrees and remove it.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
CAUTION:
Do not press the brake pedal when removing or installing the speed control deactivator switch or damage to the switch will occur.
NOTE:
The speed control deactivator switch is self-adjusting. Do not press the brake pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new speed control deactivator switch.