LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus SHO >> Repair and Diagnosis >> External Pages >> Different car >> Section 2000 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pads. For additional information, refer to BRAKE PADS - 2 PISTON .
    2. NOTE: Using specified brake cleaner, clean any residual threadlock compound from the anchor plate threads before installing the bolts.
  2. Remove and discard the 2 anchor plate bolts and remove the brake caliper anchor plate.
    • To install, tighten new anchor plate bolts to 115 Nm (85 lb-ft).
  3. Inspect the brake caliper anchor plate assembly.
    • Check the guide pins and boots for binding and damage.
    • Replace worn or damaged pins. Lubricate the pins with the specified grease.
    • Install a new brake caliper anchor plate if it is worn or damaged.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals