Toe Adjustment - Front

WARNING: This page is about a different car, the 2012 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Start the engine and center the steering wheel.
Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
Using alignment equipment and the manufacturer's instructions, measure the front toe.
Remove the clamps.

Fig 1: Locating Clamps
Courtesy of FORD MOTOR CO.
Loosen the tie-rod jam nuts.

Fig 2: Locating Tie-Rod Jam Nuts
Courtesy of FORD MOTOR CO.

NOTE: Do not allow the steering gear bellows to twist when the inner tie rod is rotated.

Fig 3: Locating Front Wheel Spindle Tie Rods

Courtesy of FORD MOTOR CO.

Rotate the inner tie rods until the toe reading is within specifications.

NOTE: Do not allow the inner tie rods to rotate while tightening the tie-rod jam nuts.

Fig 4: Locating Tie-Rod Jam Nuts

Courtesy of FORD MOTOR CO.

Tighten the tie-rod jam nuts to 55 Nm (41 lb-ft).
Install the clamps.

Fig 5: Locating Clamps
Courtesy of FORD MOTOR CO.
Recheck the toe settings and adjust as necessary.