Cylinder Head: Assembly
WARNING: This page is about a different car, the 2016 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
NOTE:
Lubricate the valve stem seal with clean engine oil prior to installation.
Using the Valve Stem Oil Seal Installer, install a new valve stem seal.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Install the valve.
- 3.
Using the Valve Spring Compressors, install the valve spring, retainer and key.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Repeat the above steps for each valve.
- 5.
Install the timing chain guide pin and/or timing chain tensioner arm pin and tighten in 2 stages.
- Stage 1: Tighten to 20 Nm (177 lb-in).
- Stage 2: Tighten an additional 60 degrees.
- 6.
Install the turbocharger oil supply quick connect fitting.
- Tighten to 16 Nm (142 lb-in).
- 7.
If equipped, install a new CHT sensor.
- Tighten to 10 Nm (89 lb-in).