Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Drain the engine coolant. For additional information, refer to ENGINE COOLING - HYBRID article.
Remove the LH lower engine splash shield.

Fig 1: Identifying Splash Shield

Courtesy of FORD MOTOR CO.

Release the clamp and disconnect the auxiliary coolant pump-to-thermostat hose.
Release the clamp and disconnect the heater outlet hose.
Disconnect the auxiliary coolant flow pump electrical connector.
Remove the 2 auxiliary coolant flow pump bolts.
- To install, tighten to 4 Nm (35 lb-in).
Remove the auxiliary coolant flow pump and rubber bracket assembly.

NOTE: Lubricate the coolant hoses with plain water only if needed. Do not use soap or other detergents.

To install, reverse the removal procedure.
- Fill the engine cooling system. For additional information, refer to ENGINE COOLING - HYBRID article.