Front Brake Pads: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Install the 2 new brake pad clips and the 2 brake pads.
- If installing new brake pads, using a suitable tool and a worn brake pad, compress the disc brake caliper pistons into the caliper.
- Position the brake caliper and install the 2 caliper guide pin bolts.
- Tighten to 36 Nm (27 lb-ft).
- Fill the brake master cylinder reservoir with clean, specified brake fluid.
- Test the brakes for normal operation.
CAUTION:
Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material. Do not install contaminated pads.
NOTE:
If installing new brake pads, install all new hardware as supplied with the brake pad kit.
CAUTION:
Protect the piston and boots when pushing the caliper piston into the caliper piston bores.
CAUTION:
Tighten the bottom caliper bolt before tightening the top caliper bolt.
CAUTION:
Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.