Front Brake Caliper: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Position the brake caliper and install the 2 brake caliper guide pin bolts.
- Tighten to 36 Nm (27 lb-ft).
- Using 2 new copper washers, position the brake hose and install the brake caliper flow bolt.
- Tighten to 34 Nm (25 lb-ft).
- Bleed the brake caliper. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.
- Test the brake system for normal operation.
CAUTION:
Tighten the bottom caliper bolt before tightening the top caliper bolt.
CAUTION:
Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.