LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 2863 (Automatic Transmission External Controls) >> Removal And Installation >> Selector Lever >> Installation

Selector Lever: Installation

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

  1. 1.

    • Tighten to 10 Nm (89 lb-in).
GFD94133Courtesy of FORD MOTOR COMPANY

  1. 2.

GFD94132Courtesy of FORD MOTOR COMPANY

  1. 3.

    NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever housing and listen for the selector lever cable retainer to click in place. Pull back on the selector lever cable to make sure that the selector lever is locked into the selector lever housing.
GFD94115Courtesy of FORD MOTOR COMPANY

  1. 4.

GFD94125Courtesy of FORD MOTOR COMPANY

  1. 5.

    Install the selector lever bezel. Refer to Selector Lever Bezel .

  1. 6.

    Adjust the selector lever cable when a new selector lever is installed. Refer to Selector Lever Cable Adjustment - 6F35  or Selector Lever Cable Adjustment - 6F50/6F55 .
scientia non olet · About LEMON Manuals