LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Taurus SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 2425 (Anti-Theft System - Perimeter) >> Removal And Installation >> Intrusion and Inclination Sensor >> Installation

Intrusion and Inclination Sensor: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector, position the intrusion and inclination sensor on the overhead console and install the 2 screws.
  2. Connect the overhead console jumper harness electrical connector to the body wiring harness.
  3. Pushing firmly, install the overhead console into the 2 clips.
  4. Download the BCM-B configuration information from the scan tool back into the BCM-B. For additional information, refer to MODULE CONFIGURATION .
  5. NOTE: The correct Integrated Diagnostic System (IDS) selections are SELF-TEST - MODULES - BCM-B and SELF-TEST - MODULES - SJB. If the IDS selections SELF-TEST - MODULES - BODY - SECURITY - PERIMETER are used, only the Smart Junction Box (SJB) is self-tested.

    Carry out the self-test (must include an on-demand self-test) for the SJB and also for the BCM-B. Clear the DTCs in both modules and then retrieve the DTCs from both modules to confirm all DTCs (in both modules) have been cleared.

scientia non olet · About LEMON Manuals