In-Vehicle Repair: Flexplate: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Install the flexplate and the 8 bolts.
- Tighten in the sequence shown in illustration to 80 Nm (59 lb-ft).
  
  Fig 1: Identifying Flexplate Bolts Tightening Sequence
  Courtesy of FORD MOTOR CO.
Install the transaxle. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F50/6F55 .
Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.