Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition switch lock cylinder.
- Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
- Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
- If equipped, remove the tilt release lever/ handle.
- Remove the 3 steering column shroud screws and the upper and lower steering column shrouds.
- Remove the key release button bolt and the key release button and spring.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.