LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Removal And Installation >> Exhaust Intermediate Pipe >> Installation

Exhaust Intermediate Pipe: Installation

  1. Position a new ball clamp on the muffler assembly.
  2. Position the intermediate pipe in the vehicle.
    3. NOTE: Similar catalytic converter or exhaust H-pipe shown in illustration.
    NOTE: Make sure that the catalytic converter or exhaust H-pipe is inserted into the couplers correctly.
  3. Slide the Torca® coupler over catalyst pipe or exhaust H-pipe and engage the coupler clip completely over the converter or H-pipe button.
    • Tighten to 48 Nm (35 lb-ft).
      Fig 1: Sliding Torca® Couplers Over Catalyst Pipes
      G06382676Courtesy of FORD MOTOR CO.
  4. Tighten the new intermediate pipe-to-muffler inlet ball clamp.
    • Tighten to 30 Nm (22 lb-ft).
scientia non olet · About LEMON Manuals