Selector Lever Knob: Installation

All vehicles 

NOTE: It is necessary to route the Transmission Control Switch (TCS) harness or select switch harness through the selector lever shroud when installing the selector lever knob.
NOTE: TCS shown in illustration, select switch similar.
Fig 1: Location of Selector Lever Knob, Screws And Shroud
Courtesy of FORD MOTOR CO.
1. Install the selector lever knob on the selector lever and install the screws.
2. Slide the selector lever knob shroud up and install it on the selector lever knob.
   Fig 2: Sliding Selector Lever Knob Shroud Upwards

   Courtesy of FORD MOTOR CO.

   Vehicles equipped with 2.5L or 3.0L (4V) engine 

3. Connect the TCS or select switch electrical connector.
   Fig 3: Location of Select Switch Electrical Connector

   Courtesy of FORD MOTOR CO.
4. Install the center console trim panel.
   Fig 4: Location of Center Console Trim Panel

   Courtesy of FORD MOTOR CO.
5. Install the selector lever trim ring.
   Fig 5: Location of Selector Lever Trim Ring

   Courtesy of FORD MOTOR CO.