Turbine Shaft Speed (TSS) Sensor: Installation

Install the TSS sensor and the bolt.
- Tighten to 10 Nm (89 lb-in).
  
  Fig 1: Locating Bolt And TSS Sensor
  Courtesy of FORD MOTOR CO.
Connect the TSS sensor electrical connector.

Fig 2: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Install the LH front structure-to-subframe splash shield and the 6 pin-type retainers.

Fig 3: Locating LH Front Structure-To-Subframe Splash Shield
Courtesy of FORD MOTOR CO.
Fill the transaxle with clean transmission fluid.

Fig 4: Locating Transmission Fluid Level Indicator
Courtesy of FORD MOTOR CO.
Start the engine and move the range selector lever into each gear position.
Using the scan tool with the engine running, check and make sure that the transmission is at normal operating temperature 85-93°C (185-200°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.