LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus Titanium, 4D Hatchback, Automatic DCT Trans, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Climate Control System -- Electric) >> General Procedures >> Refrigerant Oil Adding >> Oil Injection Using a Dye/Lubricant Injector

Oil Injection Using a Dye/Lubricant Injector

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: 2. If fluorescent leak detection dye is also to be added during A/C  charging, the dye may be added to the dye/lubricant injector, from the R-134a Loop/Add On Injector Kit-Set, along with the POE YN-32 oil.

    Evacuate the refrigerant system.

    Refer to: AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING  .

  2. 3. Assemble the dye/lubricant injector and the correct adapters to match the amount of refrigerant compressor oil to be injected.
  3. 4. Verify that all the valves on the dye/lubricant injector are closed.
  4. 5. Fill the dye/lubricant injector with the correct amount of clean, new POE YN-32 oil.
  5. 6. Install the dye/lubricant injector between the low-side service gauge port valve and the refrigerant service station or manifold gauge set.
  6. 7. Open all valves and charge the refrigerant system.

    Refer to: AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING  .

scientia non olet · About LEMON Manuals