LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Flex SE >> Repair and Diagnosis (Single Page) >> Steering >> Electronic Steering >> Steering System - Electronic Power Assist Steering >> Interactive Diagnostics >> Pinpoint Tests >> Pinpoint Test D - DTC U3000: Control Module - Actuator Stuck Open >> Normal Operation

Normal Operation

When the ignition is turned ON a relay inside the power steering control module (PSCM) is energized, which sends power to other portions of the module. The PSCM monitors this relay output and will set a DTC if output is not detected.

NOTE: If a damaged bellows boot(s) was discovered during Inspection and Verification and this pinpoint test DOES NOT lead to the installation of a new EPAS gear or bellows boot(s), then go to PINPOINT TEST K  to address the damaged boot(s) before returning the vehicle to the customer.
  1. D1: CHECK FOR RETURNING DTCS 
    • Clear the PSCM DTCs.
    • Cycle the ignition to OFF and then back to RUN.
    • Press Read Vehicle Information button to retrieve DTC s from the vehicle.
      NOTE: DTCs may be displayed from previous diagnostic actions.
scientia non olet · About LEMON Manuals