LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Escape XLS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Power Transfer Unit) >> In-Vehicle Repair >> Cover Seal >> Installation

Cover Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Halfshaft Oil Seal Installer, Rear Axle Oil Seal Installer and Handle, install the cover seal.
    • The seal is correctly installed if it is flush with the PTU case cover.
      Fig 1: Installing Cover Seal
      G06098381Courtesy of FORD MOTOR CO.
  2. Using the Handle and PTO Driven Gear Oil Seal Installer, install the deflector.
    Fig 2: Installing Deflector
    G06394110Courtesy of FORD MOTOR CO.
  3. Install the intermediate shaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals