Generator - 2.0L GTDI: Installation

WARNING: This page is about a different car, the 2013 Lincoln MKX and 2013 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Position the generator and hand tighten the 3 bolts. Tighten in the sequence shown in illustration.
- Tighten to 25 Nm (18 lb-ft).
  
  Fig 1: Identifying Generator Bolts Tightening Sequence
  Courtesy of FORD MOTOR CO.
Connect the generator electrical connector and install the nut.
- Tighten to 17 Nm (150 lb-in).
  
  Fig 2: Locating Generator Electrical Connector And Nut
  Courtesy of FORD MOTOR CO.
Position the power steering pump and install the 3 bolts.
- Tighten to 25 Nm (18 lb-ft).
  
  Fig 3: Locating Power Steering Pump And Bolts
  Courtesy of FORD MOTOR CO.
Install the upper Charge Air Cooler (CAC) pipe. For additional information, refer to Intake Air System Components - Exploded View in INTAKE AIR DISTRIBUTION & FILTERING .
Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt.

Fig 4: Rotating Accessory Drive Belt Tensioner Counterclockwise And Inspecting Proper Seating
Courtesy of FORD MOTOR CO.
Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .