LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Econoline Base, Van Cargo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 58 (Starting System) >> Removal And Installation >> Starter Motor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
WARNING: Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
    3. NOTE: The starter motor terminal cover is attached to the wiring harness.
  3. Detach the starter motor solenoid terminal cover.
  4. Remove the starter solenoid S-terminal nut and disconnect the S-terminal eyelet.
    • To install, tighten to 6 Nm (53 lb-in).
  5. Remove the starter solenoid B-terminal nut and disconnect the B-terminal eyelet.
    • To install, tighten to 12 Nm (106 lb-in).
  6. Remove the starter motor ground cable nut and disconnect the ground cable eyelet.
    • To install, tighten to 25 Nm (18 lb-ft).
  7. Remove the bolts, the stud bolt and the starter motor.
    • To install, tighten the upper bolt before tightening the lower fasteners.
    • To install, tighten to 25 Nm (18 lb-ft).
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals