Section 20 (Wheels & Tires)
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Description And Operation
- Diagnosis And Testing
- Wheels And Tires
- Notes
- Inspection and Verification
- Symptom Chart - Tire Wear
- Symptom Chart - NVH
- Pinpoint Tests
- Component Tests
- Radial Runout
- Loaded Runout Measurement (Hunter Road Force® 9700 Series Wheel Balancer)
- E-Series with Single Rear Wheel (SRW) and F-Super Duty or E-Series with Dual Rear Wheels (DRW)
- F-Super Duty Dual Rear Wheels (DRW)
- Runout Measurement (Dial Indicator)
- F-Super Duty with Single Rear Wheel (SRW)
- Match Mounting
- Wheel-to-Hub Optimization
- Tire Pressure Monitoring System (TPMS)
- Notes
- Principles of Operation
- Tire Pressure Monitoring System (TPMS) PID Definitions and Intermittent Troubleshooting
- Inspection and Verification
- DTC Chart
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test D: Tire Pressure Monitoring System (TPMS) Indicator ON CONTINUOUSLY and Message Center Displays LOW TIRE PRESSURE
- Pinpoint Test E: Smart Junction Box (SJB) Does Not Enter Sensor Training Mode When Using the Tire Pressure Monitoring System (TPMS) Sensor Training Procedure
- Pinpoint Test F: TPMS Indicator FLASHES for 70 Seconds and Then Remains ON Continuously When the Ignition Key is Turned to the ON Position, the Message Center Displays TIRE PRESSURE SENSOR or MONITOR FAULT and DTC B2872 or B287A is Present
- Pinpoint Test G: DTC B106A
- Pinpoint Test H: DTC B106B
- Wheels And Tires
- General Procedures
- Removal And Installation
- Disassembly And Assembly
- Disassembly And Assembly Of Subassemblies