LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Transit Connect Van Passenger >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Handles, Locks, Latches & Keyless Entry System >> General Procedures >> Remote Keyless Entry (RKE) Transmitter Programming

Remote Keyless Entry (RKE) Transmitter Programming

NOTE: A maximum of 4 Remote Keyless Entry (RKE) transmitters can be programmed to the vehicle. Programming must be done at the same time for all the RKE  transmitters.
    NOTE: Make sure the front doors are unlocked and closed, and the ignition is in the OFF position.
  1. Turn the ignition switch from the OFF to the RUN position 4 times in rapid succession (within 6 seconds), with the fourth turn ending in OFF. If the Generic Electronic Module (GEM) successfully enters program mode, the Instrument Cluster (IC) sounds a chime.
  2. NOTE: If no action is taken within 10 seconds after a transmitter has been programmed, the programming sequence ends.
  3. Within 10 seconds, press any button on the RKE  transmitter to be programmed. The IC  chimes to confirm that each RKE  transmitter is programmed. Repeat this step for each RKE  transmitter.
  4. NOTE: There are NO chimes or any other confirmation from the IC  upon exiting programming mode.
  5. Exiting the programming mode is accomplished if one of the following occurs:
    • The ignition transitions to the RUN position.
    • 10 seconds have passed since entering programming mode or since the last RKE  transmitter was programmed.
    • The maximum number (4) of RKE transmitters have been programmed.
  6. Check the operation of the transmitter. If the door locks do not respond for the programmed RKE  transmitter(s), wait several seconds and press the button again. If the door locks still fail to respond, refer to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS  in this service information. (Make sure that no more than the maximum number of RKE  transmitters are attempted to be programmed.)