Seat - Front: Installation

WARNING: This page is about a different car, the 2009 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The seat track-to-floor bolts must be tightened in the sequence.

NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

All seats

Position the seat in the vehicle.
Connect the seat electrical connector.
60 percent seat

NOTE: Super Cab and regular cab safety belts route differently, make sure of correct routing.

Fig 1: Locating Safety Belt Buckle

Courtesy of FORD MOTOR CO.

Position the seat fully forward and route the front center safety belt buckle through the locating strap on the side of the seat.
Install the front center safety belt bolt.
- Tighten to 55 Nm (41 lb-ft).
- If equipped, slide the front center safety belt bolt cover on the front center safety belt and position in place.
  
  Fig 2: Locating Safety Belt Buckle Bolt Covers On Safety Belt
  Courtesy of FORD MOTOR CO.
  
  All seats
Position the seat fully rearward and install the front inboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).
Install the front outboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).
Position the seat fully forward and install the rear inboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).
Install the rear outboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft).
Repower the SRS . For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .