Removal and Installation

WARNING: This page is about a different car, the 2009 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the speed control actuator electrical connector.
Remove the speed control cable cap from the speed control actuator.
- Push in the locking arm on the speed control cable cap and rotate the cap counterclockwise.
  
  Fig 1: Removing Speed Control Cable Cap From Speed Control Actuator
  Courtesy of FORD MOTOR CO.
Remove the speed control cable.
1. Press the spring retainer.
2. Slide the core wire end out of the speed control actuator pulley and remove the speed control cable.
  
  Fig 2: Removing Speed Control Cable
  Courtesy of FORD MOTOR CO.
Remove the bolt and the speed control actuator and bracket assembly.
- To install, tighten to 11 Nm (97 lb-in).
Remove the 3 bolts and separate the speed control actuator bracket from the speed control actuator.
- To install, tighten to 9 Nm (80 lb-in).
  
  Fig 3: Speed Control Actuator Bracket From Speed Control Actuator With Torque Specifications
  Courtesy of FORD MOTOR CO.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.

To install, reverse the removal procedure.