LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Ranger 2D Pickup, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Front Disc Brake System) >> Removal And Installation >> Front Disc Brake >> Removal

Front Disc Brake: Removal

WARNING: This page is about a different car, the 2009 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Remove the front disc brake caliper anchor plate. For additional information, refer to BRAKE CALIPER ANCHOR PLATE .

    Four-Wheel Drive (4WD) vehicles 

  2. Remove the brake disc.

    Rear Wheel Drive (RWD) vehicles 

  3. Remove the hub grease cap.
  4. Remove the cotter pin.
  5. Remove the hub spindle nut retainer.
  6. Remove the hub spindle nut.
  7. Remove the outer wheel bearing retaining washer.
  8. Remove the outer wheel bearing.
  9. Remove the brake disc and hub.
    10. NOTE: The wheel hub grease seal is a one-time-use part. When it is removed, a new wheel hub grease seal must be installed.
  10. Remove and discard the wheel hub grease seal.
  11. Remove the inner wheel bearing.
scientia non olet · About LEMON Manuals