Front Brake Pads: Installation

WARNING: This page is about a different car, the 2009 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not allow grease, oil brake fluid or other contaminants to contact the pad lining material, or damage to components may occur. Do not install contaminated pads.

NOTE: If installing new brake pads, install all new hardware as supplied with the brake pad kit.

Install the 2 new brake pad clips and the 2 brake pads.

NOTE: Protect the piston and boots when pushing the caliper piston into the caliper piston bores or damage to components may occur.

Fig 1: Compressing Disc Brake Caliper Pistons Into Brake Caliper

Courtesy of FORD MOTOR CO.

If installing new brake pads, using a C-clamp and a worn brake pad, compress the disc brake caliper pistons into the caliper.
NOTE: Tighten the bottom caliper bolt before tightening the top caliper bolt or damage to guide pins may occur.

NOTE: Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.

Position the brake caliper and install the 2 caliper guide pin bolts.
- Tighten to 36 Nm (27 lb-ft).
Install the wheel and tire. For additional information, refer to WHEELS & TIRES .
Fill the brake master cylinder reservoir with clean, specified brake fluid.
Apply the brakes several times to verify correct brake operation.