LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - Automatic Transaxle/Transmission - External Controls) >> General Procedures >> Selector Lever Cable Adjustment

Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Place the transmission selector lever in the D position.
  3. Lift the lock upward on the transmission selector cable lock and remove the transmission selector cable from the selector lever.
    Fig 1: Removing Transmission Selector Cable
    G06392874Courtesy of FORD MOTOR CO.
  4. Place the transmission manual control lever in the D position by rotating the manual lever clockwise to the extent of travel, then rotate counterclockwise 3 detents.
  5. Install the transmission selector lever cable on the selector lever and push the lock downward to lock the transmission selector lever cable adjustment lock.
    Fig 2: Installing Transmission Selector Lever Cable
    G06392875Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals