Passenger Air Bag Module: Removal

WARNING: This page is about a different car, the 2010 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

Depower the SRS . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
Lower the glove compartment door.
Remove the 4 bolts and position the Accessory Protocol Interface Module (APIM) aside.

Fig 1: Locating Bolts And Accessory Protocol Interface Module
Courtesy of FORD MOTOR CO.
Disconnect the passenger air bag module electrical connector.
Remove the 2 air bag module bolts.
Through the glove box opening, detach the air bag trim cover clips from the instrument panel and remove the passenger air bag module.