Starter Motor - 3.7L: Installation
- Position the starter motor and install the 2 stud bolts finger-tight.
- Tighten the upper stud bolt to 48 Nm (35 lb-ft).
- Tighten the lower stud bolt to 48 Nm (35 lb-ft).
- If equipped, position the automatic transmission cooler tube bracket and install the nut.
- Tighten to 12 Nm (106 lb-in).
- Install the wires and the 2 starter solenoid terminal nuts.
- Tighten the starter solenoid B+ terminal nut to 12 Nm (106 lb-in).
- Tighten the starter solenoid S-terminal nut to 5 Nm (44 lb-in).
- Install the starter solenoid terminal cover.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING & CABLES article.
NOTE:
To make sure of correct starter installation, the upper bolt must be tightened first.
NOTE:
Clean the starter motor mounting flange and mating surface of the starter motor to make sure there is a correct ground connection.