Lumbar Control Switch: Removal
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT in this service information.
- Remove the clip and recline handle.
- Access the clip from between the cushion cover and side shield.
- Remove and discard the cushion side shield.
- Remove the screw at the rear of the cushion side shield.
- Separate the side shield and retainers from the seat.
- If equipped, remove the seat control switch.
- Disconnect the electrical connector.
- Remove the knob.
- Remove the switch from the side shield.
- Remove the power lumbar switch.
- Disconnect the electrical connector.
- Remove the switch from the side shield.
- Remove and discard the cushion side shield.
- Remove any remaining retainers from the seat and discard.
NOTE:
Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become damaged during removal and may not remain attached if reinstalled. Install a new side shield during seat assembly.