Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.

Remove the instrument panel lower finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
With a non-marring tool, lift the corners of the console bezel upward to release the retaining clips.
Disconnect the electrical connector from the audio input jack.
Release the tabs and remove the audio input jack from the bezel.

Fig 1: Locating Audio Input Jack Tabs
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Make sure to align the finish panel retaining clips to the adjacent retaining clip holes.