LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Fiesta SES, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> MULTIFUNCTION Electronic Modules >> Removal And Installation >> Body Control Module (BCM) >> Removal

Body Control Module (BCM): Removal

NOTE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage to the module may result.
NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to a scan tool. This information must be downloaded into the new Body Control Module (BCM) after installation. For additional information, refer to MODULE CONFIGURATION . In the event that As-Built data is required (BCM  does not communicate) and the vehicle is not equipped with Intelligent Access (IA), all Remote Keyless Entry (RKE) devices must be programmed to the new BCM  . A minimum of 2 devices are necessary to complete the configuration.
  1. NOTE: This step is only necessary if the BCM  is being replaced.

    Upload the module configuration information from the BCM  into the scan tool. For additional information, refer to MODULE CONFIGURATION .

  2. Remove the RH dash closeout panel.
  3. Disconnect the 7 electrical connectors.
  4. Remove the 2 nuts and the BCM  .
scientia non olet · About LEMON Manuals