LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Fiesta SES, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> MULTIFUNCTION Electronic Modules >> Removal And Installation >> Body Control Module (BCM) >> Installation

Body Control Module (BCM): Installation

  1. Position the BCM  and install the 2 nuts.
    • Tighten to 13 Nm (115 lb-in).
  2. NOTE: If the BCM  is not being replaced, this is the last step that is necessary.

    Connect the 7 electrical connectors.

  3. Install the RH dash closeout panel.
  4. Download the BCM  configuration information from the scan tool to the BCM  . For additional information, refer to MODULE CONFIGURATION .
  5. Carry out the BCM  self-test and then repeat the self-test to confirm all DTCs have been cleared.
  6. For vehicles without IA  , program all the RKE  transmitters into the new BCM  . For additional information, refer to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
scientia non olet · About LEMON Manuals