LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Fiesta SES, Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Fuel Charging System & Fuel Control System - 1.6L) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH front seat. For additional information, refer to SEATING .
  2. Remove the scuff plate trim panel and the cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
    3. NOTE: The Fuel Pump (FP) control module is located on the rear surface of the LH front seat mount.
  3. Disconnect the FP  control module electrical connector.
    4. NOTE: Do not overtighten the fasteners or damage to the module may occur.
  4. Remove the 2 FP  control module nuts.
    • To install, tighten to 5 Nm (44 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals