Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Module configuration is required when a new ACM is being installed.

Upload the ACM configuration information to the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION SYSTEM .
Remove the instrument panel upper finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the 4 Front Controls Interface Module (FCIM) finish panel screws and rotate upwards from the bottom to release the 3 clips. Remove the Front Controls Interface Module (FCIM) finish panel.
- Disconnect the electrical connector.
  
  Fig 1: Removing Front Controls Interface Module Finish Panel
  Courtesy of FORD MOTOR CO.
Remove the ACM.
- Disconnect the ACM electrical connectors.
  
  Fig 2: Disconnecting ACM Electrical Connectors
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Download the configuration information to the ACM. For additional information, refer to PMI in MODULE CONFIGURATION SYSTEM .