Knee Air Bag Module: Installation
WARNING: This page is about a different car, the 2013 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.
- With the locking button released, install the knee air bag module electrical connector fully into the knee air bag module and seat the locking button.
- Position the knee air bag module to the instrument panel, push in and seat the retaining clips.
- Install the 2 knee air bag module nuts.
- Tighten to 8 Nm (71 lb-in).
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
NOTE:
Make sure the knee air bag module electrical connector locking button is in the released position when connected. Do not install the knee air bag module electrical connector by the locking button. Failure to follow these instructions may cause connector damage.