LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Fiesta S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Supplemental Restraint System) >> Removal And Installation >> Passenger Air Bag Module >> Installation

Passenger Air Bag Module: Installation

WARNING: This page is about a different car, the 2013 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the passenger air bag module into the instrument panel and install the nuts.
    • Tighten to 6 Nm (53 lb-in).
    2. NOTE: Make sure the passenger air bag module electrical connector locking buttons are in the released position when connected. Do not install the passenger air bag module electrical connectors by the locking buttons. Failure to follow these instructions may cause connector damage.
  2. With the locking button released, install the passenger air bag module electrical connectors fully into the passenger air bag module and seat the locking buttons.
    • Attach the wire harness retainers.
  3. Position the passenger air bag module bracket and install the nuts.
    • Tighten to 6 Nm (53 lb-in).
  4. Install the glove compartment.
  5. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  .
scientia non olet · About LEMON Manuals