Pinpoint Test
- VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
- Is an observable symptom present?
- Yes: GO to step 2 .
- No: The system is operating normally at this time. The Diagnostic Trouble Code (DTC) may have been set due to high network traffic or an intermittent fault condition.
- CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Using a scan tool, perform network test.
- Does the Cruise-Control Module (C-CM) pass the network test?
- Yes: GO to step 3 .
- No: REFER to DIAGNOSTIC ROUTINE U .
- RETRIEVE THE RECORDED Diagnostic Trouble Codes (DTCs) FROM THE Body Control Module (BCM) SELF-TEST
- Check for recorded Body Control Module (BCM) Diagnostic Trouble Codes (DTCs) from the self-test.
- Is Diagnostic Trouble Code (DTC) U3003:16 or Diagnostic Trouble Code (DTC) U3003:17 recorded?
- Yes:
For Diagnostic Trouble Code (DTC) U3003:16, REFER to DIAGNOSTIC ROUTINE H .
For Diagnostic Trouble Code (DTC) U3003:17, REFER to DIAGNOSTIC ROUTINE I .
- No: GO to step 4 .
- Check for recorded Body Control Module (BCM) Diagnostic Trouble Codes (DTCs) from the self-test.
- RETRIEVE THE RECORDED Diagnostic Trouble Codes (DTCs) FROM THE Cruise-Control Module (C-CM) SELF-TEST
- Using a scan tool, retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from the Cruise-Control Module (C-CM).
- Is Diagnostic Trouble Code (DTC) U3003:16 or Diagnostic Trouble Code (DTC) U3003:17 recorded?
- Yes:
For Diagnostic Trouble Code (DTC) U3003:16, REFER to DIAGNOSTIC ROUTINE Q .
For Diagnostic Trouble Code (DTC) U3003:17, REFER to DIAGNOSTIC ROUTINE R .
- No: GO to step 5 .
- Using a scan tool, retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from the Cruise-Control Module (C-CM).
- RECHECK THE Body Control Module (BCM) Diagnostic Trouble Codes (DTCs)
- Using a scan tool, perform BODY CONTROL MODULE (BCM) Self-Test.
- Clear the Diagnostic Trouble Codes (DTCs). Repeat the Body Control Module (BCM) self-test.
- Is DTC U0104:00 still present?
- Yes: GO to step 6 .
- No: The system is operating correctly at this time. The Diagnostic Trouble Code (DTC) may have been set due to high network traffic or an intermittent fault condition.
NOTE: If new modules were installed prior to the Diagnostic Trouble Code (DTC) being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the Programmable Module Installation (PMI) may not have been carried out. - CHECK FOR Diagnostic Trouble Code (DTC) U0104:00 SET IN OTHER MODULES
- Clear the Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Using a scan tool, retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from all modules.
- Is DTC U0104:00 set in any other module
- Yes: INSTALL a new Cruise-Control Module (C-CM). REFER to CRUISE CONTROL MODULE (C-CM) .
- No: INSTALL a new Body Control Module (BCM). REFER to BODY CONTROL MODULE (BCM) - WITH INTELLIGENT ACCESS (IA) or REFER to BODY CONTROL MODULE (BCM) - WITHOUT INTELLIGENT ACCESS (IA) .